Intex WL3110 2012 - Manual (Page 5)

155
PO
SAVE THESE INSTRUCTIONS Page 5
(155PO) POOL LIGHT ENGLISH 7.5” X 9.25” PANTONE 295U 11/18/2011
English
SS
EE
TT
UU
PP
II
NN
SS
TT
RR
UU
CC
TT
IIOO
NN
SS
SETUP INSTRUCTIONS
This product is specially designed for above ground pool. The LED pool-wall light uses
magnetic technology to create a light system that safety generates low
voltage current through the pool’s sidewall to a powerful LED light inside the pool.
IMPORTANT
• This product is for use with above ground non-steel wall pools with a thickness
of 1mm (0.04 in) or less.
• Do not use this product as a free standing light.
1. Separate the pool light (1) from the transmitter (2) by hand through the side opening
groove. See drawing (1 & 2).
CAUTION: To avoid finger pinch or injury, always separate the pool light from the
transmitter through the side opening groove.
2. Place the transmitter (2) on the outside of the pool wall and the pool light (1) on the
inside of the pool wall submerged in water. Ensure the transmitter magnetic poles are
properly aligned with the magnetic poles on the pool light unit. See drawing (3).
3. Adjust the position of the pool light by manually sliding the transmitter position sideways
and/or vertically.
4. Plug the assembled unit to an electrical outlet protected by a ground-fault circuit inter
rupter (GFCI).
1 2
WARNING
• Always unplug this product from the electrical outlet before removing, cleaning,
servicing or making any adjustment to the product.
• Do not operate the product if transmitter housing or pool light lens is cracked or
showing water leakage; remove from pool or water immediately.
• Never place the power transmitter in water.
3