Intex Deluxe Maintenance Kit For 18 FT 8 IN X 53 IN SEQUOIA SPIRIT POOL 2012 - Manual (Page 8)

(149PO) DELUXE MAINTENANCE KIT FOR SEQUOIA SPIRIT ® POOL ENGLISH 4.875” X 7.25” PANTONE 295U 11/18/2011
149
PO
S AVE THESE INSTRUCTIONS
Page 8
SETUP INSTRUCTIONS (continued)
English
SS
UU
RR
FF
AA
CC
EE
SS
KK
IIMM
MM
EE
RR
SS
EE
TT
UU
PP
II
NN
SS
TT
RR
UU
CC
TT
IIOO
NN
SS
4 The floating cover (6) should be floating off the skimmer (10) by 1" to 5"
(2.5cm to 12.7cm). Loosen the skimmer screw, slide the skimmer up and down
on the assembled hook to adjust the height. Hand tight the screw when done.
5
1
”-
5
”
(2
.5
C
M
-1
2
.7
C
M
)
Inside of the
Pool Wall
IMPORTANT: The skimmer must stay vertical at all times, so that the top of the floating
cover can parallel to the water surface for skimming.
WARNING
• Do not operate the filter pump while the pool is occupied or in use.
• Strong suction. Do not remove or obstruct the floating cover opening while the
filter pump is operating!
• Keep hands and hair away from the skimmer and floating cover opening when
the filter pump is operating!
• Turn off or unplug the filter pump before adjusting, cleaning, servicing or
removing the skimmer, basket or floating cover.
• Set up the filter pump following the filter pump owner's manual. Turn on or connect
the filter pump to an electrical outlet.
If no water is flowing into the pump, make sure that the surface skimmer is
perpendicular to the water surface and below the water surface. Open the air
release valve located on the filter housing top cover. When water starts to flow out,
close the air release valve back.
Never run the pump dry as the motor may overheat and damage the pump!
IMPORTANT
• Remove the skimmer and the hook assembly from the pool before placing a pool
cover over the pool.
• Store the product and accessories in a dry and safe place indoors.