Jas-Audio ODIN User Manual
Page 3
Unpacking Inspection
The tweeter of JAS Odin speaker is protected with a
ustomers are recommended to remove the
din Assemble Kit Setup
Transparent-Protective-Sheet to prevent damaging on
the Tweeter Unit (Dispersion Board + Driver Net)*.
C
Transparent-Protective-Sheet immediately before
using or installing on your listening system!
O
ach Odin Packing Box contains a set of Odin Assemble Kit, which carry
1. Four oversized Aluminum-
2. By turning the level screw (top of the copper-spike), the speaker can
Caution:
Do not over tighten the level-screws when
E
the feeding parts and accessories. Setup-Procedure as follow:
Bar-feeders need to be
installed at corners (Screws
and Tools attached in kit).
Well, Odin is ready to lunch
after turning up!
be leveled where it stands. Spike discs use as an option, serve to
protect your flooring from the needle sharp spikes.
installing the feet.
Doing so might risk breaking the bar
feeder holes, and level-screws become functionless. A
removable warning label has been attached at the base
of each speaker already.
Page 3 of 7
http://www.jas-audio.com