Jas-Audio PLATO - Manual (Page 5)

It is necessary for four (4) people to install the Plato, because the speaker is extremely heavy and some
handling steps necessitate a lot of care. Do not try to do any assembly without the necessary helps.
After opened up the Box-A (smaller), please keep the same action by unscrewing and removing the side
cover of the Plato Packing Box-B and Box-C (each of them contains one Plato woofer unit).
Locate and set it up one after one in its final position following the instructions detailed
below before starting to assemble the full system.
To maneuver the Plato Packing Boxes safely, you just need to open and unscrew a side cover (the marked
one side) to let it free. After removing the side cover, the Plato Sandwich is ready to land on the ground by
pulling out gently (see picture). We suggested 1 person slid it out horizontally by pulling out at the bottom
side of the wooden plate rather than the tighten belts; moreover, at least 2 people hold it to the ground side by
side as working-partner. The setup procedure captured as following clips:
ATTENION 2
Be careful all hands and fingers, 4-metal-tracking-rollers
have been attached under the Plato-Sandwich.
Now, the Plato Sandwich is ready to disassemble by unzipping the secure-belts. All
you need is to keep working on removing out all the protective-covers, and set the
Plato woofer-unit sleeps alone and stays in “neutral-position” (see bottom-right
picture).
Page 5 of 12
http://www.jas-audio.com