Jaypro Sports WMSS - Manual (Page 10)

© 2011 Jaypro Sports Equipment Release 2/22/2012
10 of 13
1. Hammer drill a hole to the same nominal diameter as the Kwik Bolt 3. The hole depth must
exceed the anchor embedment by at least one diameter. The fixture or predrilled wood plank
may be used as a template to ensure proper anchor location.
2. Clean hole.
3. Drive the Kwik Bolt 3 into the hole using a hammer. The anchor must be driven until at least
six threads are below the surface of the fixture (or wood).
4. Tighten the nut to the recommended installation torque.
Wall Type Recommended Torque
Normal and lightweight concrete 40 ft-lb
Grout filled block
25 ft-lb
Figure 6: Recommended Torque for Kwik Bolt 3 (Expansion Anchor )
Figure 7: Allowed Anchor Locations for Concrete Masonry Unit (CMU)
Hilti Kwik Bolt 3 [HIT HY 150 Adhesive Anchor System]
1. Drill anchor hole with carbide bit. Contact Hilti for use of Diamond Core bits.
2. Clean hole with wire brush. Proper hole cleaning is essential.
3. Insert air nozzle to bottom of hole and blow out hole using a pump or compressed air.
4. Put refill pack into holder. Remove cap covering threaded projection.