Jaypro Sports BLCH5CUE21 - Manual (Page 12)

© 2005 Jaypro Sports Equipment JSL-Inst034 Rev D 04-26-2010 12 of 14
i) Install Chain Link Panels:
1) Attach the pre-fabricated rear chain link panel (7) to the assembled framework. Start at one end
and attach to the three pipe clamps (15) as shown in Detail “J”. Stretch panel and connect on
opposite end, the same as Detail “J”, you may have to use a pipe for leverage to stretch.
2) Attach the pre-fabricated side chain link panels (8) to the side frames. Attach as shown on
Detail “J” using hardware (23, 30). Stretch panel as needed and connect on opposite end.
3) Slide plastic caps (17) over the exposed screw threads as shown in Detail “K”.
4) Secure the top and bottom edges of the chain link to the support pipes using the aluminum rail
ties (14) as shown in Detail “L”. Rail ties should be spaced approximately every 18”. For best
results; using a needle nose pliers, place a bend in the tie approximately 1/2” from the straight
end. Crimp this end over one leg in the edge of the chain link. Securely wrap the tie around
the support pipe and crimp the pre-bend end over and adjoining leg of the chain link.
-Pipe Clamp (15)
-5/16” x 1-1/4” Galvanized carriage bolt (23)
-5/16” Galvanized hex nut (30)
TENSION
BAR WITH
CHAIN
ITEM 17
TYP DETAIL J
TYP DETAIL K
IMPORTANT NOTE:
SLIDE PLASTICS CAPS
(17) OVER EXPOSED
SCREW THREADS.
(ADJUST LENGTH OF
CAP IF NEEDED.)