Jaypro Sports SS-320R - Manual (Page 5)

1) Assemble the pulley as shown in view ‘b’. Tighten the fasteners firmly. The
pulley is used to route the top cable of your net to the cable buckle assembly (1).
Place the completed pulley assembly at the height appropriate to the game
selected.
2) Slide the cable buckle assembly onto one upright (10) and fasten in position using
the hardware as indicated. The nylon strap should be facing upward.
3) Place an upright into each base assembly (10) and lock into place using a hex
head safety bolt 3” (8) and set screw 3/8” (7) and tighten firmly. Attach one guy
cable assembly (21) to each upright and fasten in place with a locknut 5/16” (22).
Hook the turnbuckle to the t-base and tighten the guy cable until it is partially
taut.
4) Place each base assembly over a floor plate and tighten the handknob completely
into the floor plate. For best results, permanently mark the floor at each end of
the base. This will facilitate subsequent set-ups by defining the exact base
location and floor plate position.
5) Assemble the remaining eyebolts 5/16” x 4” (3) onto each upright at the height
positions appropriate to the game selected. Clip the net’s top cable to the eyebolt
in one upright, draw the net across the field of play to the opposite upright, run the
cable end through the pulley assembly and clip the loop to the cable buckle
assembly. If the net’s top cable is too long, two 1/8” cable clamps have been
supplied so that the cable can be shortened and relooped.
6) Slowly apply tension to the net. Check the uprights to assure they have remained
plumb with the playing surface and, if necessary, tighten the guy cables slightly.
See “net tensioning instruction” for complete information on how to properly use
the patented cable buckle.
IMPORTANT NOTE:
THIS UNIT IS NOT DESIGNED FOR COMPETITION VOLLEYBALL
PLAY. EXCESSIVE TOP CABLE TENSION TO GAIN REGULATION NET
HEIGHT MAY DAMAGE THE EQUIPMENT.