Programming – Crimestopper Security Products RS701 III User Manual
Page 13
PROGRAMMING
Options Programming:
1) Open Hood (Gray wire grounded) Depress and Hold BRAKE PEDAL.
2) Press and Release program button. (Parking lights come on.)
3) Wait 2 seconds, then press and release brake pedal again.
4) Release BRAKE PEDAL
5) Momentarily Press then Release program button the number of times for the option program level desired.
Parking lights will flash the same number of times to confirm the program level.
6) Press then Release BRAKE PEDAL to increment the option value. Parking Light flashes will equal Option Value
setting to confirm programming.
7) When finished programming, CLOSE HOOD FIRST, Then press and release BRAKE PEDAL to clear parking
lights.
PROGRAMMING OPTIONS CHART
Prog. Level Option Description
Option Values
Fac. Pre-set
#1
Crank Time (in seconds)
1 = 0.75 secs.
2 = 1.25 secs.
3 = 1.75 secs.
4 = 2.25 sec.
1
#2
Engine Sense
1 = Tach
2 = Timed Crank
3 = Vacuum
1
#3
Remote Aux. Output
1 = Not Active
2 = Directed to Orange
3 = Directed to Tan
1
#4
Door Unlock Pulse
1 = Single Unlock Pulse
2 = Double Unlock Pulse
1
#5
Lock After R.S. Time/Out (Abort)
1 = Disabled
2 = Enabled
1
#6
Run Time
1 = 10 Min
2 = 20 Min
3 = 40 Min
2
EXAMPLE:
Program Remote Aux. output (Trunk Pop) channel to TAN Multi-Function wire.
1) Open Hood. Depress and Hold BRAKE PEDAL.
2) Press and Release program button. (Parking lights come on.)
3) Wait 2 seconds, then press and release brake pedal again.
4) Release BRAKE PEDAL
5) Momentarily press then Release program button 3 times. Parking lights should flash 3 times.
6) Press BRAKE PEDAL twice to get from option value #1 (default) to Option value #3. Parking Lights will flash 3
times to confirm you are at option 3.
7) Close hood, then press the brake pedal to clear.
8) The TAN wire should now be a negative output when the Trunk channel on Transmitter is pressed for 1 second
or longer.