Jaypro Sports FSGWK - Manual

WHEEL ASSEMBY KIT USG-20-42 2 1
5/8" WASHER, ZP HW2043 10 2
5/8"-11 NYLON LOCK NUT, ZP HN2945 2 3
HEX BOLT - 5/8"-11 X 6" STEEL, ZP HS5064 2 4
WHEEL 10'' x 4" NO FLAT TIRE RW5020D /
RW5020I
2 5
5/8" I.D. x 3/4" O.D. x 5/8" LONG BEARING, BRNZ HM6039 6 6
3/8"-16 x 3" HEX HD BOLT, ZP HS4081 4 7
3/8" SAE FLAT WASHER, ZP HW2047 8 8
3/8"-16 THIN NYLON LOCK NUT NTE, ZP HN1230 4 9
DESCRIPTION PART # QTY ITEM
DATE: DRAWN BY:
1/23/2013
MODEL NUMBER: CHECKED BY:
PRODUCT NAME:
Moune T.
FSGWK
FUTSAL GOAL NO FLAT WHEEL KIT
WVB
REV:
-
SHEET:
1 OF 1
T:\Aftermarket\FUTSAL GOAL\FSGWK.idw
ASSEMBLY INSTRUCTIONS
FUTSAL GOAL WHEEL KIT
TOOLS REQUIRED:
9/16 inch BOX END WRENCH AND RATCHET
15/16 in BOX END WRENCH AND RATCHET
DRILL AND 7/16 INCH DRILL BIT
4 inch C-CLAMP OPTIONAL
1) UNPACK ALL PARTS AND CHECK AGAINST PARTS
LIST TO ENSURE THAT ALL PARTS HAVE BEEN
INCLUDED
2) IF FUTSAL GOAL IS ALREADY PUT TOGETHER
REMOVE THE TWO BOLTS HOLDING THE SQUARE
BOTTOM CROSSBAR.
3) POSITION THE FIRST WHEEL ONTO THE BOTTOM
CROSSBAR AS SHOWN IN THE ILLUSTRATION AND
USING THE HOLE FROM THE BOLT YOU JUST
REMOVED ASSEMBLE USING A 3 INCH LONG 3/8-16
HEX HEAD BOLT WITH WASHERS AND NUT AS SHOWN
4) USING THE WHEEL BRACKET AS A GUIDE DRILL A
7/16 INCH DIAMETER HOLE THROUGH THE CROSSBAR
AND ASSEMBLE WITH A 3 INCH LONG 3/8-16 BOLT,
WASHERS AND NUT . USE A 4 INCH C-CLAMP TO HELP
STEADY THE BRACKET WHILE DRILLING
5) REPEAT STEPS 3 AND 4 ON THE OPPOSITE SIDE OF
THE GOAL
6) ASSEMBLE THE WHEELS TO THE WHEEL
BRACKETS AS SHOWN IN THE ILLUSTRATION, THE
INSET HUB SIDE IS ASSEMBLED WITH TWO BUSHINGS
AND CAN BE INSTALLED FACING INWARD OR
OUTWARD OF THE GOAL
1
7
8
8
9
4
2
2 3
2
5
6
2
2