Jaypro sports – Jaypro Sports VBWR-1 User Manual
Page 2
JAYPRO SPORTS
VOLLEYBALL WALL MOUNT, VBWR-1
LIST OF MATERIALS
PIECE NO. PART
NO. DESCRIPTION
QTY.
1
VBWR11
VOLLEYBALL WALL RACK
1
2
VBWR12
VELCRO STRAPS
3
3
08673
HEX HEAD LAG BOLT 5/16” x 2”
2
4
HW2049
FLAT WASHER 5/16”
2
5
HM5071
LOCKING ROLL PIN (NOT SHOWN)
6
6
RR2986
RUBBER STRIP x 3 ½”
6
INSTALLATION AND USE CONSIDERATIONS
1) Do not locate wall storage rack in or adjacent to heavy traffic areas. The stored
volleyball uprights and/or the rack may pose a hazard to those in the vicinity.
2) The straps provided with this unit will, when properly used. Safely hold an
upright which weighs 85 pounds or less. Do not exceed this working limit.
ASSEMBLY INSTRUCTIONS
1) Affix two rubber strips to each wall rack cradle. These will help to protect the
finish on your standards.
2) Locate the wall and general area where the wall rack (1) is to be mounted. Drill
two ¼” pilot holes approximately 4 ½’ above floor level and at 16” on center
from each other.
3) Using the lag bolts (2) supplied with the wall rack, or other fasteners, as needed,
secure the wall rack snugly to the wall. (see illustration)
4) When storing the upright in the wall rack, a minimum of two trained adults should
carry the unit. Be sure the upright stands vertical with no lean. Strap the upright
into the cradle by wrapping the velcro straps (2) around as tight as possible.