Jaypro Sports BB-ANCHOR - Manual

1 1 OF
PHONE:
800.243.0533 (TOLL FREE)
860.447.3001 (LOCAL)
FAX:
800.444.1779 (SALES)
860.440.0628 (ENG.)
JAYPRO SPORTS, LLC, 976 HARTFORD TURNPIKE, WATERFORD, CT 06385 USA
www.jaypro.com
THIS PRINT IS THE PROPERTY OF JAYPRO SPORTS, LLC.
AND MAY NOT BE REPRODUCED WITHOUT WRITTEN PERMISSION
COPYRIGHT 2006
JAYPRO SPORTS, LLC.
ALL RIGHTS RESERVED
REV. DESCRIPTION DATE BY
Anchor Installation
Instructions
DC 6/12/2006
BTS
Anchor Installation Instructions
DRAWN BY:
DRAWING NAME / PART NUMBER:
CHK'D BY:
ISSUE DATE:
REV. SHEET:
A
Anchor Installation Instructions
Models: BB-200, BB-400, BB-500, HP-200
1. Prepare a 10 inch square approximately 2-1/2 inches away from the base line by
digging 7 inches deep.
2. Drive the 1-1/2 inch square wooden peg, 10" in length into the center of the hole. Do not
set the wooden peg too firmly, in order to be able to remove it later. Make sure the sides
of the peg are parallel to the base line and the top of the peg is perpindiculat to the
ground level.
3. Place the ground anchor over the peg; flared end down. The bottom of the anchor should
rest on the bottom of the hole. With a straight edge, check to insure that there is a
distance of 1 inch from the top of the ground anchor to ground level.
4. In order to prevent concrete from blocking the lower end of the ground anchor tube or
from holding in the peg, press a small amound of dirt around the bottom of the ground
anchor.
5. Fill the hole with 5" of concrete. The upper end of the ground anchor should be 1 inch
above the top of the concrete. Concrete should be completely hardened before removing
the peg. Insert BB-Plug.
6. Fill hole with dirt on top of concrete, on an angle from the outer edge of the hole inward
and downward to where the ground anchor tube and the concrete meet.
MAINTENANCE: Keep ground anchors covered with BB-Plugs when not in use to prevent dirt
from getting into the anchor. Remove any dirt that might obstruct the base from entering the
ground anchor.
7 in
2 in
Concrete
BB-Plug
BB-Anchor