Jeep 2010 Liberty - Manual (Page 370)

CAUTION!
To avoid damage to your vehicle, tires, or chains,
observe the following precautions:
• Do not use tire chains on vehicles equipped with
tires other than P225/75R16 or smaller tires. There
may not be adequate clearance for the chains and
you are risking structural or body damage to your
vehicle.
• Because of limited chain clearance between tires
and other suspension components, it is important
that only chains in good condition are used. Bro-
ken chains can cause serious vehicle damage. Stop
the vehicle immediately if noise occurs that could
suggest chain breakage. Remove the damaged
parts of the chain before further use.
(Continued)
CAUTION! (Continued)
• Install chains on the rear wheels as tightly as
possible and then retighten after driving about 1 ⁄
2
mile (0.8 km).
• Do not exceed 45 mph (72 km/h).
• Drive cautiously and avoid severe turns and large
bumps, especially with a loaded vehicle.
• Use on Rear Wheels only.
• Do not drive for a prolonged period on dry pave-
ment.
• Observe the tire chain manufacturer’s instructions
on method of installation, operating speed, and
conditions for use. Always use the lower sug-
gested operating speed of the chain manufacturer
if different from the speed recommended by the
manufacturer.
5
STARTING AND OPERATING 369