Canon IMAGE RUNNER 5065 - Manual (Page 120)

NetWare Network Setup Procedures 4-2
4
U
s
ing a NetW
a
re
N
e
tw
o
rk
(Wi
ndo
w
s
)
NetWare Network Setup Procedures
To use a NetWare network, it is necessary to perform the following procedures.
1
NetWare Print Service Settings (See "NetWare Print Service Settings," on p. 4-3.)
Specify the NetWare print service settings. (Optional equipment is required to print or send a fax from a
computer. For the equipment needed, see "Optional Equipment and System Requirements," on p. 1-2.)
To specify the settings from the computer, use:
•
NWADMIN or PCONSOLE (Novell software provided with NetWare)
•
Canon utilities (NetSpot Device Installer, etc.)
2
Protocol Settings (See "Protocol Settings," on p. 4-8.)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
Canon utilities (NetSpot Device Installer, etc.)
3
Computer Settings for Printing/Sending a Fax (See "Setting Up a Computer for Printing/
Sending a Fax," on p. 4-12.)
Specify the settings of each computer you use for printing or sending a fax. (Optional equipment is required to
print or send a fax from a computer. For the equipment needed, see "Optional Equipment and System
Requirements," on p. 1-2.)
4
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 4-13.)
Specify the settings of the computer receiving data sent from the machine. (Optional equipment is required to
send data from the machine. For the equipment needed, see "Optional Equipment and System
Requirements," on p. 1-2.)
IMPORTANT
• You can specify the NetWare protocol settings if you are using the optional UFR II/PCL/
PS Printer Kit, the optional Super G3 FAX Board, or the optional Universal Send Kit.
• If you are using the optional imagePASS, for steps 1 to 3, see the manual provided with
the optional imagePASS, not this guide.
• It is recommended that steps 1, 2, and 4 above be performed by the network
administrator.
• To configure settings with software other than the control panel of the machine,
NWADMIN, PCONSOLE, or NetSpot Device Installer, TCP/IPv4 protocol must be
supported by your network environment (IPv6 is not supported).