Canon IMAGE RUNNER 5065 - Manual (Page 49)

Protocol Settings 3-3
3
Usin
g a
TCP/IP Netw
or
k
Protocol Settings
This section describes how to specify the protocol settings for the machine using
the control panel. If you are configuring the settings for the first time, use the control
panel of the machine.
After configuring the settings, you can change the content by using software other
than the control panel of the machine. For details, see "Network Setting Items," on
p. 8-2.
IMPORTANT
• When using functions to access external servers on the internet, you may not be able to
access them due to the settings of firewalls, etc. In this case, consult your network
administrator.
• If you are using the optional imagePASS, see the manual provided with the optional
imagePASS for more information on the settings (other than for e-mail/I-fax settings).
TCP/IP Settings (IPv4)
The following are the procedures for specifying the TCP/IPv4 settings from the
control panel. After configuring the TCP/IPv4 settings, confirm that the network
connections are properly set. (See "Confirming TCP/IP Settings (IPv4)," on p.
3-17.)
If you want to use IPv6 communications, follow the procedure in "TCP/IP Settings
(IPv6)," on p. 3-18 to specify the required settings, and the procedure in
"Confirming TCP/IP Settings (IPv6)," on p. 3-26 to confirm the settings.
1
On the TCP/IP Settings screen, press [IPv4 Settings]
➞ [IP
Address Settings].