Casablanca Fan Company ISOTOPE C30G45L - Manual (Page 13)

direct - touch
13 13
W-74
Wall Control
W-74 Wall control PreParation
Wall Plate
Screws (2)
Switch
Mounting
Screws (2)
(4) Wire Cap
Warning! To avoid possible electrical shock,
make certain that electricity is turned off at the
circuit breaker or fuse box before attempting any
installation or repair procedure
CAUTION! NOT turning the power OFF at the circuit breaker or fuse
box may cause damage to the electronics within the wall control and or
the PC board on the fan .
W-74 Wall control PreParation
Circuit Breaker
(Trip breaker for the
circuit you will be
working on)
Fuse Box
(Remove fuse for the
circuit you will be
working on)
Cover Plate
installing the W-74 Wall control
W-74 ContRoL inStaLLation
The wall control installs in the same manner as an ordinary light switch, using an existing wall box and
wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching
operations. For this reason the following precautions must be observed:
single W-74 installation
NOTE: W-74 Wall Control should only be installed on Casablanca's Direct-Touch TM Fans .
1. Use only the Casablanca W-74 wall control.
2. Do not use any additional control with your
Direct-Touch
TM fan (for example, dimmer, or fan
speed control).
3. Do not use more than one fan per wall control.
4. no other light fixtures or electrical appliances may
be connected on the circuit controlled by the W-74
wall control.
W-74
Red
White
Blue
Caution!
ensure power is turned oFF at the breaker or fuse panel before starting installation.
1. if you have multiple Direct-Touch TM fans, refer to the
section "changing frequency setting" on page 20.
2. remove the screws and switch plate from the existing
switch box.
3. remove the screws holding the switch in the switch box.
4. Pull the existing switch from the switch box to expose
the wire connections.
5. remove the two wires from the switch.
6. Connect the BLaCK wire from the POWEr SOUrCE
that you just removed from the switch to the BLaCK/
WHiTE STriP wire on the W-74 wall control. Secure this
connection with a wire nut.
7. Connect the second BLaCK wire that you just removed
from the switch to the second BLaCK wire on the
located on the back of the W-74 wall control. Secure this
connection with a wire nut.
Figure 1