Chroma USA 8000 - Manual (Page 5)

Model All specifications are subject to change without notice.
Debug run
The debug run provides a versatile and immediate tool for users to
verify the test items and test programs created before releasing
them to operators. All the essential debuging tools are provided
here, such as step run, set break point(s), run to break and
simultaneous variables display.Users may use this to control the
process of execution and at the mean time, monitor the test results
and verify them. As a result, there s no risk for users to put an
uncheck test item or test program onto production line.
GO/ NG run
The GO/ NG run provides friendly and easy execution environment
for production line and operators. All the test programs tested here
need to be released in management function. This may minimize
the risk of running a wrong or unchecked test program. The test
results will be stored in hard drive of the system controller which
may be used to create statistic and the test report. Plus the fail rate
check, bar code scanner support, Pass/ Fail indication TTL signal.
All these powerful features make it an ideal tool for mass
production testing.
On line control
The display tells it all. Users may achieve all the instrument on
system to control them and get readings from them. The type of
reading showing on display could be selected by user and user
may even define specifications for them. Furthermore, user can
also select them to show as a time graph in order to see the trends.
And, the waveform measured by DSO can be merged onto the
same display as well. The waveform can be downloaded as hard
copy or digitizing waveform. Under digitizing mode. Users can
select measurement parameters just like it provides in DSO. In a
word, this execution mode is the implementation of virtual
instrumentation.
The selected variables will be updated simultaneously
when the test item or test program is under going.
Failure rate check function is available in GO/NG
execution mode.
Users allow to create their own softpanel layout
and store it for recall later.
Versatile and powerful execution mode
Chroma PowerPro III software platform provides three execution modes. DEDUG RUN is used to verify the user-defined test items and test
programs. For production line testing, GO/ NG RUN allows one key operation to perform Pass/ Fail test. And the On-LINE-CONTROL mode
extends Chroma Power Supply Auto Test System model 8000 to control and monitor the hardware devices simultaneously. Thus, it is capable
of simulating the manual test scenarios just like you did on the bench.