Compatible Systems 1220I - Manual (Page 32)

26 Chapter 6 - Basic Configuration Guide
Frame, and InterfaceDLCI keywords in the IP WAN 0 (and/or
any other port you wish to configure) section.
Suggested for IP
These parameters help supply information about the segment that the
interface is connected to. With this information, routing can take place.
• Set IP RIP 1, IP RIP 2, or OSPF (Open Shortest Path First)
• IP static routes
CV: Use the TCP/IP Routing: WAN Dialog Box to set RIPor OSPF,
and the IP Static Routing Dialog Box (under Global/IP Static
Routes) to set static routes.
TB: Use configure and set either the RIPVersion keyword or the
OSPFEnabled keyword in the IP WAN 0 (and/or WAN 1)
section. Add static routes and a default router using the edit
config IP Static command.
IPX Protocol
Required for IPX
Frame Relay operation requires that the WAN interface is set to be a
“numbered interface.” This means that the interface (and thus the
Frame Relay network) must have an IPX network number.
• IPX numbered interface
• IPX Network Number
CV: Use the IPX Routing: WAN Dialog Box.
TB: Use configure and set the Numbered and Net keywords in the
IPX WAN 0 (and/or WAN 1) section.
Suggested for IPX
The settings above are all that is generally required for IPX operation
over Frame Relay.