CatEye EC-C400R - Manual (Page 8)

8
3
Mount the seat and handlebar.
• Mount the seat to the seat pipe using the large screws and the
handlebar using the small ones.
Connect the Inner pipe.
• First, connect the pulse sensor cables.
Caution: If the connection is incomplete, the pulse rate will not
be displayed. Be sure to fully insert the connector.
• Insert the front end of the inner pipe into the joint of the main unit and
fasten it securely with the two screws and the grip.
4
5
Caution: • To prevent the connected cord from becoming
slack, bundle the cords into the inner pipe. If the
pipe is inserted though the cord is not taut, the cord
may get caught, result in disconnection.
• When removing the inner pipe, ensure that two
persons carry out this task. When removing the in-
ner pipe, the pulse sensor cord may be pulled acci-
dentally resulting in disconnection.
Small screw
Flat washer
Spring washer
Seat
Large screw
Spring washer
Flat washer
Handlebar
Seat height
lock knob
Rear support pipe
Screws
Pulse sensor cable
Joint fitting
Inner pipe
Excess
Fold
Grip
Assemble the rear frame.
• Loosen and remove the seat height lock knob.
• Insert the rear support pipe into the socket of seat pipe. Select any
height and tighten the knob.