Cobra Electronics PR3100DX - Manual (Page 10)

Customer Assistance Warranty Introduction
15 Nothing comes close to a Cobra ™
Operation
Privacy Code Scan
•
Your microTALK ® radio can automatically scan the Privacy Codes
(00 through 38) within one (1) channel.
To Scan Privacy Codes:
1. While in Standby mode, press the Channel
Up or Channel Down button to choose the
channel on which you wish to scan privacy
codes.
2. Press the Mode button until the Scan icon and
the privacy code numbers flash on the display.
3. Press the Channel Up or Channel Down
button to begin scanning privacy codes
within the channel you selected.
The Scan icon will continue to be displayed when
privacy code scan is On. Your radio will continue
to scan privacy codes and stop as an incoming
transmission is detected. Your radio will remain
on that channel/privacy code for ten (10)
seconds.
While setting privacy code scan, if you do not
press any buttons for 15 seconds, your radio
will automatically return to Standby mode on
the channel/privacy code that was displayed
before you entered mode functions.
14 English
Mode Functions
During Channel Scan (while receiving an incoming transmission),
You Can Choose From The Following:
a. Press and hold the Talk button to communicate on that
channel. Your radio will remain on that channel and return
to Standby mode.
b. Press the Channel Up or Channel Down button to resume
scanning channels.
If you press the Talk button while scanning and not within ten (10)
seconds of receiving a transmission, you will transmit on the
channel on which you last received a transmission. This will return
the radio to Standby mode.
If you do not press any button within ten (10) seconds, your radio
will automatically resume scanning channels.
During Channel Scan (while not receiving a transmission),
You Can Choose From The Following:
a. Press and hold the Talk button to communicate on the channel
or channel/privacy code that was displayed before you entered
mode functions or the channel on which, during scanning,
you last received a transmission. This will return the radio
to Standby mode.
b. Press the Mode button to proceed to set privacy code scan on
the channel that was either displayed before you entered mode
functions or on which, during channel scanning, you last
received a transmission (see page 15 for further details).
c. Press the Lock button to return to Standby mode on the
channel/privacy code that was displayed before you entered
mode functions or the channel on which, during scanning,
you last received a transmission.
Operation
Channel Button
Mode Button
Select Channel
Scan Privacy Codes
3100-PDF VERSION.qxd 11/20/03 10:41 AM Page 14