Panasonic SPX900 - Manual (Page 111)

111
8
8-6-6 TC/UB
8-6-7 UMID SET/INFO
<Note>
Please refer to [4-5-6 Setting the UMID Information] for the
UMID information setting.
The ____ in the Adjustable Range column indicates the preset
mode.
Items/
Data Saved
Adjustable
Range
Remarks
UB MODE USER
TIME
DATE
EXT
TCG
FRM RATE
REGEN Select the user bits mode.
USER:Select UB value set in the LCD
section.
TIME: Select local time (hours, minutes,
seconds).
DATE: Select local date and time (2 last
digits of year, month, date, time).
EXT: Slaved to UB from TC-IN. If reading
fails, USER value is retained.
TCG: TCG value enters UB.
FRM RATE:
Select same camera shoting
information (frame rate, etc.) with the
VAUX UB (VITC UB).
REGEN:Read out value stored in the card
and record value continuously. – C U F –
VITC UB MODE USER/EXT
TIME
DATE
TCG
FRM RATE
REGEN
Select the user bits mode for VAUX TC
(VITC).
USER/EXT:
If UB MODE is set to EXT, the EXT
value is recorded. If not, USER value
set by UB is recorded.
TIME: Select local time (hours, minutes,
seconds).
DATE: Select local date and time (2 last
digits of year, month, date, time).
TCG: TCG value enters UB.
FRM RATE:
Select same camera shoting
information (frame rate, etc.) with the
VAUX UB (VITC UB).
REGEN:Read out value stored in card and
record value continuously. – C U F –
TCG SET HOLD ON
OFF
ON/OFF switching for the feature that
always starts recording (when the power is
turned ON again) the TCG value that was
set before the power is turned OFF.
– C U F –
FIRST REC TC REGEN
PRESET
For the first recording after the power is
turned on, a P2 card is inserted and then
switching from this P2 card to another
recording-target P2 card is performed,
select whether or not to regenerate the time
code as the value on the new P2 card.
REGEN:For clips recorded on the recording-
target P2 card, regenerate the time
code as the time code of the clip that
has the most recent date and time.
PRESET:
Use the camera-recorder’s internal
time code.
<Note>
Set the date and time accurately. For
guidance on setting, see [4-5-2 Setting the
Internal Clock’s Date and Time].
– C U F –
P.OFF LCD
DISPLAY ON
OFF Select whether or not to display the time
code setting and counter indication on the
LCD monitor when the power is turned OFF.
ON:
Display setting and indication while
the power is turned OFF.
OFF: Power-down LCD monitor while
camera power is turned OFF. Setting
and indication disabled.
– C U F –
Items/
Data Saved
Adjustable
Range
Remarks
TC OUT TCG
TCG/TCR Select the time code to be output to the time
code output connector.
TCG: Always output time code generator
value.
TCG/TCR:
Display time code generator value in
E-E mode, and time code reader
value in V-V mode.
– C U F –
Items/
Data Saved
Adjustable
Range
Remarks
COUNTRY NO-INFO Input the user’s country. NO-INFO is
displayed until the input completes.
– C U F –
ORGANIZATION NO-INFO Input the user’s organisation or company
name. NO-INFO is displayed until the input
completes.
– C U F –
USER NO-INFO Input the user name. NO-INFO is displayed
until the input completes.
– C U F –
DEVICE NODE Indicate the product ID number.
– – – – –