Panasonic SPX900 - Manual (Page 71)

71
5
Reading out the Lens File Data
1
Select the lens file No. to read out by following Steps
1
to
3
in the [Storing the Lens File Data] section.
2
Turn the JOG Dial button to move the cursor to [READ:].
3
Press the JOG Dial button and the following message
appears.
4
Turn the JOG Dial button to move the cursor to [YES].
Then, press the JOG Dial button.
[READ OK] will be displayed after the stored lens file data
has been read out.
5
Press the MENU button to exit the menu operation.
Resetting Lens File Data to Factory Standard Settings
The lens file data can be reset to the standard setting values that
were set when the camera was shipped from the factory.
From the FILE page, open the <INITIALISE> screen.
1
From the INITIALIZE screen, select [RESET LENS FILES].
2
When the JOG Dial button is pressed, the message shown
below appears.
3
Turn the JOG Dial button to move the cursor to [YES], then
press the JOG Dial button.
[OK] is displayed, resetting the lens file data to the factory
default values.
5($'"
<(6
 12
,1,7,$/,6(!
 5($')$&725<'$7$
:5,7(86(5'$7$
5(6(7/(16),/(6
5(6(7$///(16'$7$"
<(6
 12