Panasonic SPX900 - Manual (Page 89)

89
7
7-3 Warning System
7-3-1 Warning Description Tables
If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the WARNING lamp,
lamps inside the viewfinder and a warning tone.
<Note>
The WARNING lamp has the highest priority, followed by the tally lamp, and then the warning tone. When multiple errors occur
simultaneously a higher priority indication will be triggered. The [WIRELESS RF], however, may not be indicated, depending on the
menu setting.
1. System Errors
Display window
indication
The error code lights up.
WARNING lamp Blinks 4 times per second.
Tally lamp Blinks 4 times per second.
Viewfinder
The SYSTEM ERROR indication and the error
code light up.
Warning tone Beeps continuously.
Warning
description An error in the reference signal or the
communication.
Recording/
playback operation
The operation stops.
Countermeasures
Please confirm [7-3-2 Error Codes] and consult
your nearest service center.
3. Battery Empty
Display window
indication All 7 bar indicators for battery remaining capacity
start blinking.
WARNING lamp Lights up.
Tally lamp Blinks once per second.
Viewfinder The BATT LED lights up.
Warning tone Beeps continuously.
Warning
description
The battery has run out.
Recording/
playback operation
The operation stops.
Countermeasures Replace the battery.
2. Card removal error
Display window
indication
Error code E-30 appears.
WARNING lamp Blinks 4 times per second.
Tally lamp Blinks 4 times per second.
Viewfinder The “TURN POWER OFF” indicator blinks.
Warning tone Continues to beep.
Warning
description
The P2 card being accessed has been removed,
resulting in an error in the internal memory of the
camera-recorder.
Recording/
playback operation
Cannot be performed.
Countermeasures
Turn off the power to the camera-recorder. If
there is an error in a clip on the removed P2 card,
repair the clip.
4. Write-protect
Display window
indication All 7 bar indicators for remaining MEDIA capacity
start blinking.
WARNING lamp
Continues to light up until an operation is
performed.
Tally lamp
Continues to blink 4 times per second until an
operation is performed.
Viewfinder The WP indicator blinks.
Warning tone
Continues to beep until an operation is
performed.
Warning
description
The inserted P2 cards are write-protected.
Recording/
playback operation
Recording is disabled.
Countermeasures Disable the write-protect or replace the P2 card.