Entering a passcode, Entering passcodes -6, Entering a passcode -5 – Conair MPA User Manual

Page 37: Ntering a, Asscode 1 2 3 4

Advertising
background image

UGH004/0999

microKool Portable Chillers

O

PERATION

4-5

PC-1 and PC-2 controls have a security feature that prevents
accidental or unauthorized changes to the setpoint tempera-
ture, high and low deviation limits, SPI address, and baud rate.

If passcode protection is enabled, you must enter the correct
passcode to change these parameters. To enter the passcode:

Press and hold the Setpoint Select button
for 5 seconds.

The control will display 1 PaS to indi-

cate a passcode is needed.

Press the Select ▲ button until the correct
passcode appears in the display.

Press again to enter the passcode.

If the passcode is correct, the control displays ACC PAS
for 3 seconds. If the passcode is incorrect, the control dis-
plays rEJ PAS (rejected passcode).

Press Setpoint to select the parameter you
want to change.

You will have access to the system parameters until:

● The power is cycled off and on.
● The RUN or STOP button is pressed.
● No key has been pressed for 30 seconds.

NOTE: Pressing the STOP or RUN key while you are
entering a passcode will abort the passcode entry
sequence

E

NTERING A

P

ASSCODE

1

2

3

4

Advertising
This manual is related to the following products: