Compaq AA-RHGWC-TE User Manual

Page 67

Advertising
background image

•

The lower righthand device slot of the BA370 shelf within the RA7000
or ESA 10000 RAID array subsystems. This position minimizes cable
lengths and interference with disks.

A DS-DWZZH-05 UltraSCSI hub uses the storage shelf only to provide its
power and mechanical support (it is not connected to the shelf internal SCSI
bus).

______________________

Note

_______________________

When the DS-DWZZH-05 is installed, its orientation is rotated
90 degrees counterclockwise from what is shown in Figure 3–3
and Figure 3–4.

The maximum configurations with combinations of DS-DWZZH-03 and
DS-DWZZH-05 UltraSCSI hubs, and disks in the same storage shelf
containing dual 180-watt power supplies, are shown in Table 3–3.

______________________

Note

_______________________

With dual 180-watt power supplies installed, there are slots
available for six 3.5-inch SBBs or two 5.25-inch SBBs.

Table 3–3: DS-DWZZH UltraSCSI Hub Maximum Configurations

DS-DWZZH-03

DS-DWZZH-05

Disk Drives

a

Personality
Module

b c

5

0

0

Not Installed

4

0

0

Installed

3

0

3

Installed

2

0

4

Installed

1

0

5

Installed

0

2

0

Not Installed

3

1

0

Not Installed

2

1

1

Installed

1

1

2

Installed

0

1

3

Installed

a DS-DWZZH UltraSCSI hubs and disk drives may coexist in a storage shelf. Installed disk drives are not
associated with the DS-DWZZH UltraSCSI hub SCSI bus segments; they are on the SCSI bus connected to
the personality module.

b If the personality module is installed, you can install a maximum of four DS-DWZZH-03 UltraSCSI hubs.

c The personality module must be installed to provide a path to any disks installed in the storage shelf.

Shared SCSI Bus Requirements and Configurations Using UltraSCSI Hardware 3–11

Advertising