Chicago Electric 65588 - Manual (Page 6)

SKU 65588 For technical questions, please call 1-800-444-3353. Page 6
tant information. If unreadable or
missing, contact Harbor Freight Tools
for a replacement.
Have the equipment serviced by a
6.
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the equip-
ment is maintained. Do not attempt
any service or maintenance proce-
dures not explained in this manual
or any procedures that you are un-
certain about your ability to perform
safely or correctly.
Store equipment out of the reach of
7.
children.
Follow scheduled engine and equip-
8.
ment maintenance.
refueling precautions:
Do not smoke, or allow sparks, a.
flames, or other sources of ignition
around the equipment, especially
when refuelling.
Do not refill the fuel tank while the
b.
engine is running or hot.
Do not fill fuel tank to the top. Leave
c.
a little room for the fuel to expand as
needed.
Refuel in an exterior, well-ventilated
d.
area only.
BasIc specIFIcatIons
Fuel
Type
89+ Octane unleaded
gasoline.
Capacity 0.6 US Gallons
Engine Oil
Type
SAE 30W Above 32° F
SAE 10W-30 Below 32° F
Capacity 0.2 QT.
Run Time @ 50%
Load
Approximately 4 Hours
(with full tank).
Sound Level 93 dB
Power Output
950 W Rated, 1000 W
Peak
Receptacles
120 V ~ 7.9 A Rated
Duplex Receptacle 12 V
DC 65 Receptacle.
note: Additional specifications found in
the TECHniCAL EnGinE SpECifi-
CATIONS chart in this manual.
The emission control system for this
engine is warranted for standards
set by the U.S. Environmental
Protection Agency and by the
California Air Resources Board
(also known as CARB). For
warranty information, refer to the
last pages of this manual.
At high altitudes, the engine’s
carburetor, governor (if so
equipped), and any other parts
that control the fuel-air ratio will
need to be adjusted by a qualified
mechanic to allow efficient high-
altitude use and to prevent
damage to the engine and any
other devices used with this
product.
unpacKIng
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.