Crate Amplifiers BT1000 - Manual (Page 8)

BT1000 TECHNICAL SPECIFICATIONS:
Output Power Rating 100W RMS 2% THD, 4
Ω
, 120 VAC
Gain Clean Channel 56dB
Expander 62dB
Tone Range Low 20dB @ 50Hz
Lo Mid 24dB @ 150Hz
Hi Mid 18dB @ 1kHz
High 32dB @ 10kHz
Expander 22dB @ 330Hz
Signal To Noise Ratio 65dB below full power, tones flat, gain and level @ “10”
Maximum Input Signal Level Accepted 15 volts peak-to-peak
Balanced Line Out Jack 2 volts peak-to-peak @ full rated power w/600 ohm load
Internal Speaker Size 12”
Type Crate Custom
Magnet 28.5 oz
Voice Coil 1.5”
RMS Rating 100 watts
Impedance 4 ohms
Input Power Requirements 120 VAC, 60Hz, 115VA
100/115VAC, 50/60Hz, 115VA
230VAC, 50/60Hz, 115VA
Size 19-1/4” H x 15” W x 16” D
Weight 53 lbs
www.crateamps.com
@2005 SLM Electronics, a division of St. Louis Music, Inc • 1400 Ferguson Avenue • St. Louis, MO 63133
47-781-01 • 030805
B T 1 0 0 0
Bass Amplifier
Specifications subject to change without notice