Classe Audio Power Amplifier CA-2200 - Manual (Page 23)

23
Specifications
Classé Audio reserves the right to make improvements without notice.
■ Power output 200W/ch continuous rms @ 8Ω
(both channels driven) 400W/ch continuous rms @ 4Ω
■ Frequency response 10Hz – 22kHz (+0/-0.1dB)
10Hz – 155kHz (+0/-3.0dB)
■ Phase better than -10° @ 22kHz
■ Signal-to-noise ratio 108dB
(ref. full ouput, 10Hz – 80kHz)
■ Channel separation better than 110dB @ 20kHz
■ Noise floor (FFT) all peaks less than -95dBV
(10Hz – 80kHz)
■ Distortion (THD + noise) 0.003% @ 8Ω
(unweighted, 1.0Vrms/1kHz input, 10Hz – 500kHz)
■ Voltage gain 29.1dB
■ Sensitivity 1.4Vrms for rated output @ 8Ω
■ Input Impedance 100kΩ
■ Rated power consumption (as per IEC60065 para. 2.3.10) 480W
■ Idle power consumption 166W
■ Mains voltage specified on rear panel
(cannot be changed by dealer or user).
■ Dimensions (not incl. controls or connectors) Width: 17.5” (445mm)
Height: 8.75” (222mm)
Depth: 18.5” (470mm)
■ Shipping weight 92lbs (42kg)
■ Net weight 80lbs (36kg)
For more information, see your Classé dealer, or contact:
Classé Audio
5070 François Cusson
Lachine, Quebec
Canada H8T 1B3
Telephone
+1 (514) 636-6384
FAX +1 (514) 636-1428
http://www.classeaudio.com
email: [email protected]
Classé and the Classé logo are trademarks of Classé Audio Inc. of Lachine, Canada. All rights reserved.
i-Command™ is a trademark of Equity International, Inc. All rights reserved.
AMX® is a registered trademark of AMX Corporation of Richardson, TX. All rights reserved.
Crestron™ is a trademark of Crestron Electronics, Inc. of Rockleigh, NJ. All rights reserved.