Produits Neptune 48 KARMA - Manual (Page 7)

F G
8
H
30
9
10
Interior
STEP 8 Threshold installation
Take measurement between the door guide and the wall and
cut the threshold at this length.
Make sure to protect the threshold with masking tape before
cutting it, making sure not to damage the chrome finish.
Apply a thin bead of silicone to its underside and position it on
the base aligned with the fixed glass panel.
Keep the threshold in place with masking tape.
STEP 9 Door swipe and wheel installation on door panel
Place door swipe #30 under the door, lip towards shower interior.
Align to the edge of the glass panel situated against the return
glass panel side and trim the excess.
Position the wheel on the front of the panel (Figure 9) placing a
metal ring and a plastic washer between the wheel and the glass.
Screw from inside, verify for proper integration of the plastic nut
inside the hole of the glass panel making sure the wheel is as
low as possible on the door (turn the white plastic nut for this
adjustment).
Firmly screw and repeat the operation with the second wheel.
STEP 10 Door panel installation
Position the door panel on the support bar.
Make sure the wheels are well rested on the bar and integrate
the panel into the door guide.
Slide the door panel towards the wall and verify alignment.
If needed, to correct the alignment, slightly loosen the wheels
and, while supporting the weight of the door on the wheels
(one at a time), turn the white plastic nuts with the provided
plastic wrench until the door is well aligned.
Firmly screw the wheels, ensuring not to unsettle the door lev-
el.