Chicago Electric 1/2 Heavy-duty Low Speed VSR Drill 93632 - Manual (Page 9)

Page 9 For technical questions, please call 1-800-444-3353. Item 93632
SAFETY
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURY FROM AccIDENTAL OpERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to Parts List and Diagram on page 14.
Assembly
1. Align the D-Handle Knob through the
D-Handle into the Back Cover. Secure the
D-Handle Knob by turning clockwise until tight.
2. Thread the Side Handle into the Gear Housing Cover
by turning clockwise until tight.
There are three possible positions: left, top, and right.
Note: Periodically check to be sure the Handles
remain tight. Do not reposition the Handles
while the tool is running or plugged in.
Features
chuck
Side
Handle
D-Handle
Trigger Lock
Direction Switch
Speed control
Trigger
This tool incorporates a double gear reduction transmission to reduce drill speed while increasing torque.
This design improves performance when drilling large holes. This feature also helps
prevent the tool from “bogging down” or stopping when under heavy load.