Kenton Korg Monopoly - Manual

User instructions for Kenton MIDI retrofit for
KORG MONOPOLY
These instructions are only for Monopoly MIDI retrofit kits produced after 1
st
January 2006
Firmware KGMP5100 or later
N.B. Different instructions apply to earlier Kenton Monopoly MIDI retrofit kits.
USING THE MIDI INTERFACE
When you turn on the synthesizer for the first time, you will be in omni-off mode channel 1 for receive. - See the
following pages for other factory default settings. When you select a receive channel, this will be stored in memory
and will be remembered for when you subsequently turn on the synth - all parameters listed on the next page are
stored.
If you want to put the machine back to the factory default settings at any time, switch the synth on whilst holding the
red push button pressed - hold for a couple of seconds then release.
RED PUSH BUTTON
Two modes are available by pushing the red push button during normal playing mode. Before you press the red
button however, make sure that no keys are pressed on the remote MIDI keyboard otherwise the results may be
unpredictable. The key presses for editing can only be entered on the remote 61 key MIDI keyboard.
1) SET-UP MODE
For setting MIDI channels and assignments. Give the red push button two short presses (half a second each) - then
release. Follow this with a key or sequence of keys as detailed on page 2. After making a MIDI channel assignment,
you will be automatically returned to playing mode but after making other assignments you will need to press the
ENTER key (Top C) to return to playing mode. This is to enable you to make the multiple key presses required
when re-assigning Sources to Destinations. (N.B. all set-ups are stored in non volatile memory).
2) TRANSPOSE MODE
Press and hold the red push button for about four seconds - then release. Middle C will sound on the synth and
continue to sound until you press a key. The key that you press will be the new middle C for MIDI IN. You can set
any value up to two octaves up or down - settings outside this range will be ignored. Note that transpose mode
cannot be entered from set-up mode. (N.B. the transposition will be stored in non volatile memory).