Keri Systems Alarm Relay - Manual (Page 3)

Alarm Relay Board
Installation Guide
Page 3 of 3 P/N: 01513-001 Rev. A
NXT Tamper Connection
•
allows the NXT controller to record an Enclosure Tamper event
• requires two-conductor, AWG 22 wire
4.0 Unit Operation
The ARB is operational as long as power is supplied to the unit. Two LEDs on the ARB provide unit
status.
• Red LED – indicates alarm condition
• Green LED – indicates non-alarm condition
Verify tamper switch operation by toggling the tamper switch(es) and observing the red and green
LEDs follow tamper switch state.
Contact Keri Systems:
End of document.
Keri USA Keri UK, Ireland, Europe
2305 Bering Drive
San Jose, CA 95131 Unit 17
Park Farm Industrial Estate
Ermine Street
Buntingford
Herts SG9 9AZ UK
Telephone: (800) 260-5265
(408) 435-8400 Telephone: +44 (0) 1763 273 243
Fax: (408) 435-7163 Fax: + 44 (0) 1763 274 106
Web: www.kerisys.com Web: www.kerisystems.co.uk
E-mail: [email protected]
[email protected] E-mail: [email protected]
[email protected]