Keri Systems Doors.NET Quick Start - Manual (Page 4)

Part no. 01565-001 4 Version 1.0
o Select the Gateway and then click on the Next button and then the Finish button. The
NXT Gateway service will be restarted.
•
Launch the Administrative Client.
o The default username is: admin, the default password is: admin.
•
Perform an Autoconfig
Autoconfig queries the local subnets for each NXT Gateway and returns a list of NXT Controllers
found on the network. Note: The DoorsNXTProxy.exe service must be allowed to communicate
through any firewall installed on the computer running the NXT Gateway service. The
DoorsNXTProxy Service is added to the list of exceptions in the Windows Firewall during
installation, however if another firewall is being used, it may prevent Autoconfig from finding the
controllers on the Local LAN. The following Port numbers are used for Doors.NET
communication and should be allowed to pass through a firewall – UDP 11434&11435, TCP
10020, 10030, 11000-11015 &11435.
o Click on the Setup tab and then on the Manual Config button in the Hardware Toolbar.
o In the Hardware Setup tab, click on the All tab and then select the NXT Gateway. The
Auto Config icon will appear in the tool bar. Click on the Auto Config button.