KERO Bench Seat for PakCanoes - Manual (Page 3)

C. Dismantling the seat.
1. Loosen the knobs under the seat. Undo the elastic bands from the latch clips.
2. Lift the rear latches and pull the seat forward out of the latches.
3. Lift the plastic rings above a forward rail bracket. Lift the bracket out of the plastic ring below it.
Repeat on the other side of the canoe.
4. Unlock the C-clips on the cross rib holding the forward rail bracket. Lift the latches and remove the
cross rib part way. This will change the angle between the cross rib and the bracket, and the bracket
will release easily.
5. Disconnect the rear end of the rail by lifting the upper rings off the bracket and lifting the bracket off
the lower rings. Lift the front end of the rail, and the rear bracket will disconnect easily.