Pre-delivery check list, Delivery check list, Introduction – Classen 60-RT User Manual

Page 3: Owner’s record

Advertising
background image

1

PRE-DELIVERY CHECK LIST

Check the following before you deliver the Aerator to the
customer.

1.

Guards and shields fastened in place.

2.

Decals fastened and legible.

3.

Weight bar installed.

4.

Gas lever on engine turned on.

5.

All lubrication points greased.

6.

6:1 gearbox oil level.

7.

Engine oil level.

8.

Air cleaner.

9.

Touch up scratches.

10. Chain(s) tight.

11. Lowering handle working properly.

12. Control handle(s) working to tighten V-belt(s).

13. Add fuel, start engine, test run.

DATE SET UP __________/__________/__________

DELIVERY CHECK LIST

Review the operators manual with the customer.

1.

Classen Mfg., Inc. warranty.

2.

Safe operation and service.

3.

How to use controls.

4.

Operating the machine correctly.

5.

Transporting the Aerator.

6.

Correct fuel and lubricants.

7.

Daily and periodic inspections.

8.

Changing oil after break-in period.

9.

Servicing the Aerator regularly and correctly.

10. Classen Mfg., Inc. parts and service.

11. Give the customer the operators manual and

encourage customer to read it.

DATE DELIVERED __________/__________/__________

SIGNATURE _______________________________________

INTRODUCTION

THANK YOU

Thank you for purchasing a CLASSEN Aerator

READ THIS MANUAL

Read this manual carefully in its entirety. It contains safety,
operating, maintenance, and adjustment instructions for your
Aerator. By following the operating and maintenance
instructions you will prolong the life of your equipment and
maintain its maximum efficiency. Failure to do so could result
in personal injury or equipment damage.

This manual should be considered a permanent part of your
Aerator and should remain with it if you sell it.

WARRANTY

Refer to last page.

MEASUREMENTS

U.S. Units of measure are used in this manual.

SERIAL NUMBERS

Write frame and engine serial numbers, plus model numbers in
“Owner's Record” section below. You may need these numbers
when you order parts. The serial number stick plate is located
on the right rear of the Aerator frame.

ORDERING PARTS

When ordering parts, always give the serial number and model
of your Aerator as well as the quantity, part number and
description of the part needed.

DIRECTIONS

“Right Hand” and “Left Hand” sides of the Aerator are
determined by facing the "back" of the Aerator as you would
operate the machine.

OWNER’S RECORD

DATE PURCHASED _________________________________

AERATOR MODEL NUMBER _________________________

AERATOR SERIAL NUMBER _________________________

ENGINE MODEL NUMBER __________________________

ENGINE SERIAL NUMBER___________________________

Advertising
This manual is related to the following products: