Kuzma 4POINT 81126 - Manual (Page 13)

13
11. Maintenance
The bearing does not need maintenance. Clean dust from the tonearm with a dry cloth and use
a soft cloth and alcohol to remove silicone oil.
12. Transport
During transport the tube assembly must be removed from the horizontal bearing assembly.
To do this you must remove the vertical paddle. Remove vertical trough and reposition cable
on the tube assembly.
If you transport a turntable with tonearm, ensure that hard vibration from the car does not
transmit directly to the tonearm. Placing soft material such as rubber, foam or a thick blanket
below the turntable is helpful in filtering rough vibrations even when the platter is removed.
13. Problems
1. Cartridge jumps in the inner grooves: See if the tube can travel towards the centre of the
record- check that position of the tonearm is correct with protractor for distance.
2. Cartridge is too close to the record edge: Check if the tube travels too much toward the
centre of the record- check that position of the tonearm is correct with protractor for distance.
3. Headshell cannot be removed- check that the screw is released enough with Allen key.
Kuzma Ltd
Hotemaze 17A
SI-4205 PREDDVOR
SLOVENIJA
P: +386 4 25 35 450
F: +386 4 25 35 454
E mail:[email protected]
www.kuzma.si