Kuzma Stabi S 100420 - Manual (Page 6)

6
Belt:
Place the belt over the subplatter and over the motor pulley. Check by manual rotation that
the belt runs smoothly in the middle of the motor pulley groove.
Power connection:
Plug into the mains, being aware that there is no mains connection indicator. Press the
black switch and ensure that the belt is runing properly.
Platter:
Remove the platter ( Fig. 5 ) from its protective bag while keeping the protective cover on
the mat. Place the platter carefully on top of the subplatter. Check again the position of the
motor pulley in relation to the bottom surface of the platter. Remove plastic mat protection.
Press switch again and check that the platter reaches full speed in about 4 seconds.