Kuzma Stabi REF 2 101014 - Manual (Page 6)

6
Platter:
Position the platter on the subplatter, holding the platter with both hands at the sides. Due to
the small gap between the lower edge of the platter and the top of the subchassis, do not hold
the platter underneath. Hold it firmly, so it will not slip.
Setting up the turntable
Suspension adjustment:
Adding or subtracting mass from the subchassis will affect its height above the base chassis.
Height adjustment is by rotation of the black knobs on the top.
Turning the adjustment knobs anticlockwise causes the subchassis to rise. If you look from
the side between the base chassis and subchassis you can see a line marked on each
suspension tower 7 mm above the base chassis. Adjust the height of the subchassis by turning
all 4 knobs so that the lower edge of the subchassis is level with the markings on all towers.
The best way to do this is to adjust two opposing knobs a little, then another two knobs a little
and the first pair again, etc. At this stage do not be too precise as the armboard and tonearm
have yet to be added and they will lower the subchassis height.
Position of the lower edge of the subchassis Belt position
Test suspension: The subchassis should move a few mm in all directions if gently pushed and
then return to its original position.
Belt:
Lift up the platter and position the belt onto the motor pulley in a diamond shape. Due to the
lack of mass, the subchassis will be higher and belt position is a little slanted. If you can push
the subplatter down near the spindle you will be able to rotate the subplatter for a few turns
with the other hand and the belt will slip into its correct position.
Now add the platter and rotate it by hand.