Kuzma Stabi XL 4 101014 - Manual (Page 5)

5
Base:
Locate the main brass base with the shaft. This is very heavy. Lift, being careful not to
scratch against metal parts of clothing, and position in the middle of the supporting board.
The Kuzma logo should face forward. Use a ruler to position the centre of the base.
Subplatter:
Remove the protection cover from the shaft and see if there are any dirt particles in the area
of shaft and ruby ball. Remove these using a soft cloth and further clean the area if
necessary with a cloth soaked in alcohol.
Oil should be poured into the reservoir on top of the shaft (where the ruby ball is located )
until it is full and oil starts to run into the lower reservoir. Then empty the rest of oil into
this lower reservoir. The level of oil is not critical due to the construction of the bearings.
Note: there is a spare bottle of oil!
Carefully put the aluminium subplatter over the shaft as vertically as possible and gently
lower by rotating it back and forth. When lowered, ensure that rotation of the subplatter feels
free and firm. If your hands are sweaty or sticky from the oil, clean the outer surfaces of the
subplatter with a cloth soaked in alcohol.
Fig 3
Motor towers:
Remove the two brass motor towers with the black pulleys, being careful not to touch the
pulleys with any force. Position each motor separately, one in front of the base(the motor
tower with the Kuzma logo) and the second motor tower at the rear of the base so that the
connectors are at the rear side. All four motor towers should form a square. The gap between
the base and the motor towers should be at least 20 mm. See fig 2.Then add supporting plates
for motor towers. The thinner plate raises the front motor tower and the thicker plate supports
the rear motor tower. Reposition motor towers to achieve 112 mm distance from subplatter to
outer edge of motor pulley after positioning platter. Use motor positioner on top of pulley by
simply just touching the edge of the platter. See fig 4.