Kuzma STABI XL 4 KIT- FOR CONVERTING STABI XL2 TURNTABLE - Manual (Page 3)

3
Unpacking:
The boxes and some parts are very heavy, so handle very carefully and place parts on
assembley surface.
Contents:
Motor towers 2x, belts 2x, motor towers support platform 2x, connecting cables 2x, PS XL II,
motor positioner, instruction manual.
Basic setup
Motor towers:
Remove the two brass motor towers with the black pulleys, being careful not to touch the
pulleys with any force. Position each motor separately, one in front of the base(the motor
tower with the Kuzma logo) and the second motor tower at the rear of the base so that the
connectors are at the rear side. All four motor towers should form a square. The gap between
the base and the motor towers should be at least 20 mm. See fig 2.Then add supporting plates
for motor towers. The thinner plate raises the front motor tower and the thicker plate supports
the rear motor tower. Reposition motor towers to achieve 112 mm distance from subplatter to
outer edge of motor pulley after positioning platter. Use motor positioner on top of pulley by
simply just touching the edge of the platter. See fig 3.
Distance of motor towers. Fig. 2.
Position of belts from lowest upwards:
1-old tower-right- lower groove
2-old tower-left- upper groove
3-new tower-front-upper groove( thinner support plate)
4-new tower-rear-lower groove ( thicker support plate)