LAARS Multi Flue CF-100-3 - Install and Operating Manual - Manual (Page 3)

3
General Information
Note: It is recommended that the installation and service of this water heater be
performed by a plumbing professional.
This water heater must be installed in accordance with local codes. In the absence of
local codes, it must be installed in compliance with the National Fire Protection
Standard For Oil Burning Equipment NFPA No. 31 (latest edition). In Canada the
installation of this water heater shall be in accordance with the regulation of authorities
having jurisdiction and CSA STANDARD B139.
The warranty of this water heater is in effect only when the water heater is installed,
adjusted, and operated in accordance with these installation and operating instructions.
DO NOT use this appliance if any part has been submerged in water. You should
contact the plumbing professional who installed the water heater to inspect the
appliance and to replace any part of the control system and any component which has
been submerged in water.
A sacrificial anode is used to extend tank life. The removal of this anode, for any
reason, will nullify the warranty. In areas where water is unusually reactive, an odor
may occur at the hot water faucet due to a reaction between the sacrificial anode and
the impurities in the water. If this should happen, an alternative anode may be
purchased from the supplier that sold you this water heater. This will minimize the odor
while protecting the tank. Additionally, the water heater should be flushed with
appropriate dissolvers to eliminate any bacteria.
INSTALLATION
Locating the water heater
The location of this water heater is of the utmost importance. Before installing the water
heater, you should select a location where the floor is level and is easily accessible to
water supply lines as well as to a chimney or vent. DO NOT locate the water heater
where water lines could be subjected to freezing temperatures.
This water heater MUST be installed indoors out of the wind and weather.
Note: For California installation this water heater must be braced, anchored, or
strapped to avoid falling or moving during an earthquake. See instructions for
correct installation procedures. Instructions may be obtained from California
Office of the State Architect, 400 P Street, Sacramento, CA 95814.
Minimum Clearances
This water heater shall be installed on NON-COMBUSTIBLE flooring only. This water
heater may be installed in an alcove. Refer to the marking on the front of the water
heater for clearances to combustible materials.
The installation should allow access to the front of the water heater and adequate
clearance should be provided for servicing and operating the water heater. It is
recommended that a minimum clearance of 3” be provided on the side of the water
heater for servicing and maintenance of the temperature and pressure relief valve.