LAARS NeoTherm LC NTV1700 - Users Manual - Manual (Page 12)

LAARS Heating Systems Page 10
GENERAL CARE
Keep the area around the neotherm LC clear and free from combustible materials,
gasoline and other flammable vapors and liquids. Clean the jacket surfaces with a damp
cloth and mild soap. Do not use flammable cleaning materials. Keep the vent terminal
free of obstructions. do not pile snow against the vent terminal.
ANNUAL INSPECTION AND SERVICE
You should visually inspect the vent pipe once a year. should any corrosion or leaks
exist, have the affected parts replaced.
Once each year a qualified service agency should conduct a detailed inspection of all flue
product carrying areas of the boiler and vent system. Follow the service instructions in
the “installation and operating instructions Manual” for the neotherm LC.
Caution
Do not use this boiler if any part has been under water.
Immediately call a qualified service technician to inspect the
boiler. Any part of the control system and any gas control which
has been under water must be replaced.
WARNING
If the unit overheats or the gas supply fails to shut off, do
not turn off or disconnect the electrical supply to the pump.
Instead, shut off the gas supply at a location external to the
NeoTherm LC.
En cas de surchauffe ou si l’admission de gaz ne peut être
coupée, ne pas couper ni débrancher l’alimentation électrique
de la pompe. Fermer plutôt le robinet d’admission de gaz à
l’extérieur de l’appareil.
FOR SERVICE
Contact your installing contractor, gas utility, Laars dealer, or check www.Laars.com for
the nearest authorized representative in your area.
H2353000-
800.900.9276 • Fax 800.559.1583 (Customer Service, Service Advisors)
20 Industrial Way, Rochester, NH 03867 • 603.335.6300 • Fax 603.335.3355 (Applications Engineering)
1869 Sismet Road, Mississauga, Ontario, Canada L4W 1W8 • 905.238.0100 • Fax 905.366.0130
www.Laars.com
Printed in U.S.A. © Laars Heating Systems 1210 Document 1256
Dimensions and specifications subject to change without notice in accordance with our policy of continuous product improvement.