LABEC M-HOG010 - Manual (Page 4)

2
III. OPERATION INSTRUCTION
1.
It should keep at least 1 cm of the distance between the tip of the
stirring shaft and the inside bottom of the vessel. Don’t let the
homogenizer head touch to the bottom of the vessel.
2. Rotate the speed adjuster knob toward the left end; then plug in the
power cord and switch the machine on.
3.
Press “START” button and adjust to the desired speed; press “STOP”
button to stop the stirring.
4. For avoid idle running, the flowing speed of the liquid should be
available to the stirring speed of the machine.
5. After a long time use, if the motor temperature over 75 degree C, the
over-heat protection device will start and stop the motor running.
When the temperature come down (about 30 mins later), the machine
can re-start to run. If the situation repeats to happen, User should
reduce the loading on the machine. Don’t overload the machine;
otherwise its motor will be damaged possibly.
6.
Using the homogenizer heads alternately is available. Just need
release the fixing screw under the homogenizer head, the
homogenizer head can be taken off easily.
7. The homogenizer head is available to be dismantled, so users can
clean it after the operation.