Leapers Flip-to-Side 25mm/1 Tactical Flashlight Ring w/QD Mount (RG-FL25QS) - Manual (Page 2)

INSTALLATION GUIDE
5.Tighten the 3 locking screws
with the included Allen wrench in
an alternating pattern to complete
installation. Do not over-tighten
the screws.
Compatible UTG Products
1.Remove the end cap of the lighting device.
2.Slide the appropriate insert(s) over the body of the light device.
The end with flange goes on first toward the front of the lighting
device. If using 2 inserts, slide Insert A over the light body first,
followed by Insert B.
3.Slide the tube of the lighting device, with inserts if applicable, into
the ring and replace the end cap.
4.Ensure inserts are mounted flush against the ring. Adjust the ring
mount position on the tube.
CAUTION: The flip-to-side feature is built on a very robust base with
strong spring tension for repeated use. DO NOT attempt to flip the
ring sideways or upward when it is not mounted on your firearm with
a flashlight or laser.
1 2
3 4
5
Item
RG-FL25QS
RG-FL27QS
No Insert
Fits 25mm Tube
LT-EL268Q
LT-TL099PR2
LT-ZL168
LT-EL268Q
LT-TL099PR2
LT-ZL168
LT-EL228Q
LT-EL338Q
LT-ELF240
LT-ZL337Q
SCP-LS269
SCP-LS279
SCP-LS288
SCP-LS269
SCP-LS279
SCP-LS288
Fits 27mm Tube Fits 25mm Tube Fits 20mm Tube
Fits 20mm Tube
With Thick Insert
(A)
With Thin Insert
(B)
N/A
N/A
N/A
With Both Inserts
(B) Over (A)
MUM031011210