Levana Ovia Manual - Manual (Page 16)

Mounting the Camera on a Wall Safely:
Before drilling the holes, it is important to check the reception and camera positioning in the intended location on the wall.
Ensure you are hanging the camera no less than 3 feet away from baby’s crib.
1. Pre-drill one hole in the wall using a 3/16”, 4.8mm drill bit.
2. Insert a wall anchor (not included) into the hole and tap gently with a hammer until the anchor is flush with the wall.
3. Insert a screw (not included) into the wall anchor and tighten until the screw only sticks out about a 1/2 inch.
4. Plug the power cord into the power input of the camera.
5. Locate the wall mounting hole on the bottom of the camera base.
6. Slide the hole over the screw sticking out of the wall.
7. Confirm that the camera is secure, if it is loose you may have to tighten the screw more.
8. Use wall clips (not included) to secure the power cord away from the crib or the
baby’s reach.
9. Connect the other end of the adapter into an available wall outlet.
Note: Baby monitors and cameras with power cords should never be hung on or near the crib as it is a strangulation
hazard. Power cords should be kept no less than 3 feet away from the crib and the baby’s reach at all times.
OPERATION
16 mylevana.com