Existing hole, Existing threaded hole, Fig. c – Lippert Components CBB07 Bumper Brace Installaion User Manual
Page 2: Fig. d
Bed
Cross
Member
Existing
Hole
Fig. C
Step 3a. (2007-2010 only)
Secure the upper end of the
frame brace rod to the bed cross member
using the existing hole near the end
of the cross member. Secure with
3/8” x 1” bolt and hardware provided.
(except on dually trucks) See fig. C
Note:
On Dually trucks there will be a
fender brace attached to this hole. Remove
the bolt from the fender brace, place the
bumper brace under the fender brace and
reinstall the bolt.
Step 3b. (2011 & Newer)
Install upper end of bumper brace at location
shown in Fig. D using the Metric M8-20
hardware supplied. (Except dually trucks)
Note:
On Dually trucks there will be a
fender brace attached to this hole. Remove
the bolt from the fender brace, place the
bumper brace under the fender brace and
reinstall the bolt.
Step 4. Set lower (bumper) end of the
frame brace 1” away from body panel and
tighten both ends of frame brace.
Bed
Cross
Member
Existing
Threaded
Hole
Install with
M8-20
Bolt, washer
& lock washer
Fig. D