Lippert Components CA-FD7 - Manual (Page 2)

1. Looking at the end of the bumper, locate and mark a point mid way (center) from left to right,
and 1-1/8” down from bottom of inset. (See Fig. 3 below)
2. Center punch, then drill 1/8” pilot hole at this point.
3. Enlarge hole to 1/2”.
4. Install anchor bolt as shown in Fig. 3, with the flat surfaces horizontal.
5. When loading camper, slide the angled tie down coupler (Fig. 4) over the anchor bolt
and insert turnbuckles into the eye of the coupler.
It is best to slip the turnbuckle hook through the coupler from the truck side outward.
NOTE: When camper is not loaded, remove and store Tiedown Couplers to avoid loosing them.
REAR ANCHORS
Fig. 3
NOTE: The diagram below shows driver’s side installation. The same procedure and dimensions
apply to the passenger side installation.
Fig. 4
Tiedown Coupler