Lippert Components Ground Control 3.0 OEM - Manual (Page 4)

Rev: 01.30.2015 Page 4
Ground Control 3.0 OEM Installation Manual
Fig. 2
Fig. 2 Detail
A
Installation - Rear Sensor
The rear sensor (Fig. 2A) MUST be installed on the crossmember to the rear of the back axle, centered curbside to
roadside on the unit with the arrows on the top of the sensor pointing the correct direction (Fig. 2 detail).
1. Dry fit the mounting plate (Fig. 3A) and the rear sensor (Fig. 3B) to the crossmember (Fig. 3C). The pre-
drilled holes in the plate are for mounting the rear sensor to the plate. Mark on the plate where the rear
sensor will set. Space between the sensor and the crossmember MUST be left so the wire harness will
not be pinched.
Fig. 3
A
B
C
Rear
Front