Lippert Components Ground Control 3.0 - Manual (Page 7)

Rev: 01.30.2015
Page 7
Ground Control 3.0 Troubleshooting Guide
GROUND CONTROL 3.0
TROUBLESHOOTING GUIDE
Auto Level Sequence
1. Front landing gear retract, lowering the front of the unit below level,
stopping, then lifting the front end to level the unit front to back and left
to right. (Fig. 7A).
2. Rear leveling jacks are grounded (Fig. 7B).
3. A side to side leveling sequence occurs.
NOTE: At this point on the 6-Point system, the two middle jacks are grounded
to stabilize the unit. These two jacks do not level the unit (Fig. 7C).
4. Each jack will perform a final grounding touch.
5. LCD will read "AUTO LEVEL SUCCESS".
NOTE: If the auto level sequence does not happen as stated above, check to
ensure proper manual mode function.
Hitch Recognition
1. Turn on touch pad.
2. Press the left and right buttons simultaneously (Fig. 8A and 8B).
3. All leveling jacks will retract first, then the landing gear will extend to
raise the unit to the height where the auto level sequence was started.
NOTE: If the auto level sequence was started with the front of the unit in a
below-level condition, the Hitch Recognition will not function and
the LCD will display “Feature Disabled.” In order for hitch recognition
feature to function, the auto level sequence MUST be started with the
front of the unit above level.
Fig. 7
Fig. 8
A
B
A
B
C
D
C