Lippert Components 5th Wheel Hydraulic Slideout And Landing Gear (hlg) System - Manual (Page 17)

17
MECHANICAL ROOM ADJUSTMENT-CONT.
Jam Nut-1
Jam Nut-2
Fig. 9
Nylock Nut
Adjusting room so it seals in the IN position:
1. Locate hydraulic cylinder coming through the frame.
2. On the end of the hydraulic cylinder there is a threaded rod
mounted to the drive bracket with 3 nuts.
3. Loosen the Jam Nut-1 and set Jam Nut-2 to desired location.
4. Tighten down the Nylock Nut against bracket. Make sure Jam Nut-2
is snug against bracket. Secure assembly by tightening Jam Nut-1
against Jam Nut-2. This will change the location of your seal going
to the “in position”.
Adjusting room so it seals in the OUT position:
1. Locate hydraulic cylinder coming through the frame;
2. On the end of the hydraulic cylinder there is a threaded rod mounted
to the bracket with 3 nuts.
3. Move one of the nuts, (Jam Nut-2 or Nylock Nut) one way or the
other– this will change the location of your seal going to the “out
position”.
4. Make sure all nuts are tight.