Lippert Components Hydraulic Through Frame Slideout - Manual (Page 18)

Rev: 07.09.2014
Page 18
Hydraulic Through Frame Slideout Owners Manual
Extend and retract cylinder port locations
Rod End Piston Rod
Cap End Stud
Extend Retract
Rod End Piston Rod
Cap End Stud
Extend
Retract
Standard Slideout Cylinder
Trunnion Slideout Cylinder
Manual Override
The Lippert Hydraulic Slideout System can be run with auxiliary power devices like electric drills, ratchet wrenches
or cordless screwdrivers. In the event of electrical or system failure, this manual method of extending and retracting
the slideout room can be used. A standard hand-held drill is all that is required. A standard 38" room will take
approximately 45 seconds to retract. See the instructions below.
1. Remove protective label (Fig. 1).
2. Using a standard hex bit, insert into auxiliary drive device (cordless drill, screwdriver, or ratchet
wrench).
3. Insert hex bit into coupler found under protective label (Fig. 2).
4. Run drill forward or clockwise to extend slideout room and in reverse or counterclockwise to retract
slideout room.
Fig. 1 Fig. 2